Manual FältCom ECII SE Eng
Page 30 of 36
A call will be disconnected automatically three minutes after the last key pressing. With thirty
seconds to disconnection, a warning tone will be heard. To prolong the call, press
4,
ACKNOWLEDGE
.
End the alarm call by pressing
0, END.
If the alarm is ended with time disconnection, replaced
receiver, or lost contact and either
Simple phone acknowledge
or
Disconnection of
acknowledgement
is programmed the FältCom ECII SE will make a new alarm call to the next
programmed alarm receiver.
8.1.2 Speech
exchange
If the automatic speech exchange is not satisfactory, you can change to manual speech
exchange
8, TALK
and
7, LISTEN
. Revert to automatic speech exchange by pressing
4,
ACKNOWLEDGE
.
8.1.3 Termination of active alarm mode
If the function alarm mode activated and the product is in active alarm mode, you can finish it
by pressing the key
5,
TERMINATE ALARM MODE
. The call is automatically disconnected.
8.1.4 Forwarding
a
call
If you want to forward the alarm to the next alarm receiver, press
2, FORWARD
. The alarm is
then closed, and the lift phone will call the next programmed alarm receiver.
8.2 Calls to a lift phone
If answering function is activated, or if alarm mode function is programmed, and FältCom ECII
SE is in active alarm mode, it is possible make a call to FältCom ECII SE from a tone dialing
phone or a mobile according to the following:
1.
Dial the number to the lift phone.
2.
After four ring signals the first FältCom ECII SE answers and sends a 3-tone.
3.
Press # and ID-number to the wanted lift phone (1-6). For instance #2 for lift phone 2
in the chain. Note that #1 must be pressed by the caller even if only one lift phone is
mounted.
4.
Press 4 to activate voice connection.
5.
Press 5 to terminate a possible active alarm mode. Then the call is disconnected.
6.
Press 7 to listen.
7.
Press 8 to speak.
8.
Press 0 to disconnect the call
