Manual FältCom ECII SE Eng
Page 27 of 36
7.2.11 Change of alarm flashing sequence
When the alarm button has been activated and an alarm is registered by the lift phone, the
LED in the FältCom ECII SE become yellow. When the alarm is acknowledge the LED
becomes green. This flashing sequence is according to EN81:70.
There is an option to change to a flashing sequence which indicates a registered alarm with
flashing green light and acknowledged alarm with fixed green light. This is done with the
following programming sequence:
Return to the yellow/green flashing sequence by programming:
7.2.12 Programmable alarm type
The normal alarm type 10 (0Ah) may be mapped to another alarm type. The function is
activated with the keyboard sequence:
<
XX
>
where
XX
represents an alarm type between 00 and 99. To restore the alarm type to the
default value, enter:
Note that FältCom ECII SE always assumes that the programmed alarm type is speech-
connecting.
7.2.13 Unit ID
When a standard telephone is used as alarm receiver FältCom ECII SE can simplify the
identification of the lift phone by sending out beeps. It can be useful when many FältCom ECII
SE are sharing the telephone line and number presentation is used for identification. It is then
impossible to know from which of the up to 6 lift phones the alarm came from. The function is
activated with:
and deactivated with:
When the function is active, the FältCom ECII SE will replace the normal beep sequence with
a start beep, followed by sequence of beeps with another frequency. The number of beeps in
the sequence is controlled by the first digit in the alarm code. If the alarm code is 345678 the
lift phone will start with a beep and the play out 3 beeps with a different frequency. If the first
digit is zero, 10 beeps will be played.
