English
37
Positioning the Cooker
The diagrams show the minimum rec-
ommended distance from the cooker
to nearby surfaces.
The hotplate surround should be level
with, or above, any adjacent work
surface. Above hotplate level a gap of
75mm should be left between each
side of the cooker and any adjacent
vertical surface.
For non-combustible surfaces (such
as unpainted metal or ceramic tiles)
this can be reduced to 25mm.
A minimum space of 650mm is re-
quired between the top of the hotplate
and a horizontal combustible surface.
Any cooker hood should be installed
in accordance with the hood manu-
facturer’s instructions.
For safety reasons curtains must not
be fitted immediately behind the
cooker.
We recommend a gap of 1110mm be-
tween units to allow for moving the
cooker. If a flush fit is required, fit the
cooker up to the unit at one side then
fit the unit the other side.
A clearance of 130mm is required if
the cooker is near a corner of the
kitchen to allow the oven doors to
open.
Unpacking the Cooker
Do not take any packaging off the
cooker until it is directly in front of the
place it is to be installed (unless it will
not fit through a door in its outer pack-
aging).
Levelling
You are recommended to use a spirit
level on a shelf in one of the ovens to
check for level.
Place the cooker in its intended posi-
tion taking care not to twist it within
the gap between the kitchen units as
damage may occur to the cooker or
the units.
The rollers can be adjusted to level
the cooker. To adjust the height of the
rear of the cooker use the levelling
tool supplied to turn the adjusting nuts
at the front bottom corners of the
cooker.
Adjust the height of the front roller to
level the cooker. Turn clockwise to
raise the cooker and anticlockwise to
lower.
When you are satisfied with the
height and level raise the front of the
cooker by one turn of the front roller
adjuster. Screw down the front feet to
meet the floor. Screw the front roller
adjuster anticlockwise to raise the
front roller so that the front of the
cooker is supported on the feet, not
the front roller, to prevent accidental
movement of the cooker.
Leave the levelling tool in the storage
drawer, so that the customer can use
it if they wish to move the cooker.
Replace the drawer by locating on
side runners and push in.
Fit the Handles
Remove the 4mm Allen screws from
the doors. Use the screws to fit the
door handles.
The handles should be above the
fixings.
The handles should be above the
fixings. Fit the plastic blanking plugs
to the fixing holes.
Remove the 4mm Allen screws from
the top corners of the fascia and fix
the front handrail in position.
Fitting the splash back
It is essential the splash back is fit-
ted. Remove the two fixing screws
(3mm hexagonal socket head) and
nuts that pass through the top of the
rear flue grille. Hold the splash back
in position. From the rear refit the 2
fixing screws and nuts.
