SERVICING WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
19
Conversion to LP
If the appliance is to be converted to LP gas do the conversion
at this point. See the conversion section of these instructions.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust the
height of the rear of the cooker use the levelling tool supplied
to turn the adjusting nuts at the front bottom corners of the
cooker.
Adjust the height of the front roller to level the cooker. Turn
clockwise to raise the cooker and anticlockwise to lower.
When you are satisfi ed with the height and level raise the front
of the cooker by one turn of the front roller adjuster. Screw
down the front feet to meet the fl oor. Screw the front roller
adjuster anticlockwise to raise the front roller so that the front
of the cooker is supported on the feet, not the front roller, to
prevent accidental movement of the cooker.
Gas Connection
Fitting a stability bracket
A stability bracket or chain (not supplied by with the cooker)
should be fi tted when the cooker is connected to a fl exible gas
supply. Any restraining device should be secured to the fabric
of the building and should be able to be released so that the
cooker can be pulled out for cleaning and maintenance.
When fi tting a stability bracket read these instructions together
with the leafl et supplied with the bracket.
1. Place the cooker in its intended position and level the
cooker.
2. Draw a pencil line 100mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring 550mm
from the left hand side of the cooker.
4. Lower the front roller and move the cooker forward.
5. Measure back from the pencil line 550mm to locate the
front edge of the bracket. Fix the bracket to the fl oor.
6. Measure the height from fl oor level to engagement
edge in back of cooker. Add 3mm to this dimension and
assemble the stability bracket to this height. (i.e. from
fl oor level to underside of the top member) and ensure
the bracket does not foul the oven burner assembly.)
Gas Connection
A gas shut off valve must be fi tted between the gas supply and
the connection hose. The fl exible hose (not supplied with the
cooker) must be in accordance with the relevant standards. If in
doubt contact, your supplier.
view from the rear
A
position of pressure test point screw
B
appliance gas inlet
C
position for gas supply connector
