10
English
The Ovens
To avoid damage to the interior enamel, DO NOT
line the base of the oven with aluminium cooking
foil.
The ovens have panels that have been coated with
a special enamel that partly cleans itself. This does
not stop all marks on the lining, but helps to reduce
the amount of manual cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below this
temperature, occasionally remove the panels and
wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced
and the oven heated at 200°C for about one
hour. This will ensure the Cook & Clean panels are
working eff ectively.
Don’t use steel wool (Brillo), scourers or any other
materials that will scratch the surface. Don’t use
oven cleaning pads.
Removing the Oven Linings
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves fi rst.
On some models the
right hand fanned
oven has a removable
oven roof - if fi tted
slide the roof liner
forward and remove.
The side panels of either oven can be removed.
Each side of the oven is fi xed with four fi xing
screws. You don’t have to remove the screws to
remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then pull
them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
When replacing the linings fi t the side linings fi rst.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy; two people may be required
to move it.
The cooker is fi tted with one roller at the front and
two at the back. There are also two screws down
levelling feet at the front.
The front roller, designed for moving the cooker,
can be wound down. The levelling tool that
controls this roller should be in the storage drawer
compartment. If you cannot fi nd the levelling
tool, contact your installer. See the start of the
‘Installation’ section of these instructions where
they should have entered their details.
To remove the drawer
Pull the drawer forward. Lift up the ends of the
plastic clips (one each side) to release the catches
holding the drawer to the side runners and at the
same time pull the drawer forward and away from
the side runners.
For safety’s sake push the drawer runners back out
of the way.
A left rear roller, B right rear roller, C centre roller
Locate the Allen key tool as shown.
Turn the levelling tool clockwise, two full (180°)
turns. It will be stiff . The front of the oven will rise
slightly as the roller drops down.
