56
English
24. To Remove Oven Element.
Disconnect from electricity supply.
Remove oven inner back (see 22).
Remove 2 screws from the top of the element and 1 from
the bottom of the element in side the oven.
Lift element out carefully, disconnect the terminals
connected to the element noting their positions. If it is not
possible to disconnect the leads in this way, pull cooker
forward to gain access to the rear, remove screws securing
the electric cover to the back sheet and remove cover and
disconnect the terminals from the rear.
Fit new element, and reassemble in reverse order. Check
operation of oven.
25. To Remove the Left Hand Oven Bottom & Top
Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the rear
of the unit. Remove the fi xings that secure the cover and lift
it clear.
Remove the 2 screws ‘A’ and allow the plate to drop down.
Remove the 2 screws B, lower the upper plate and remove
through the slot in the cooker back.
Undo the terminal connections, noting their positions.
Remove the element fi xings and withdraw element. Replace
the element and re-assemble parts in reverse order.
Top Element
Open the oven door and undo the fi xings that secure the
heat shield. Remove the top element bracket fi xings and
withdraw element. Replace the element and re-assemble
parts in reverse order. Check that the oven operates
satisfactorily.
26. To change oven light bulb.
Turn off the power supply.
Make sure the oven is cool. Open the oven door and remove
the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It may be
very stiff .
Taking care to protect your fi ngers in case the bulb should
shatter, unscrew the old bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Screw in the new bulb, screw back the bulb cover. Turn on
the electricity supply and check that the bulb now lights.
27 To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the angle of
the door.
Loosen the bottom hinge fi xing screws and use the notch
and a fl at bladed screwdriver to move the position of the
hinge to set the hinge position.
Retighten the hinge screws.
Eff ect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
