48
English
Installation
This appliance is designed for domestic cooking only. Use
for any other purpose could invalidate any warranty or
liability claim.
Before installation, ensure that cooker is suitable for your
gas type and supply voltage. See the appliance data badge.
Check the data badge to determine which gas the cooker is
set for.
Conversion
This appliance is supplied as: -
G 20 20millibar
CAT II2E3+
A conversion kit for other gases is supplied with the
cooker. If the appliance is to be converted to another gas
we recommend that this is done before installation. See
the Conversion Instructions packed with the conversion
kit. After converting the appliance please attach the Gas
Conversion sticker over the appropriate area of the data
badge, this will identify the gas type the appliance is now
set for.
Safety Requirements/Regulations
This appliance must be installed by a competent person.
The installation must comply with the relevant regulations
and also the local electricity supply company requirements.
Read the instructions before installing or using this
appliance.
In your own interest and that of safety, it is law that all gas
appliances be installed by competent persons. Failure to
install the appliance correctly could invalidate any warranty
or liability claims and lead to prosecution.
Before installation, ensure that cooker is suitable for your
gas type and supply voltage. See the data badge.
Install in a well-ventilated space.
Provision of Ventilation
This appliance is not connected to a combustion products
evacuation device. It shall be installed and connected in
accordance with current installation regulations. Particular
attention shall be given to the relevant requirements
regarding ventilation.
Local regulations regarding ventilation must be adhered to
but as a minimum:
All rooms require an openable window or equivalent, while
some rooms require a permanent vent in addition to the
openable window. The cooker should not be installed in a
bedsitting room with volume less than 20m3. If it is installed
in a room of volume less than 5m3 an air vent of eff ective
area 100cm2 is required; if it is installed in a room of volume
between 5m3 and 10m3, an air vent of eff ective area 50cm2
is required; while if the volume exceeds 11m3, no air vent
is required. However, if the room has a door that opens
directly to the outside, no air vent is required even when the
room volume is between 5m3 and 10m3. If there are other
fuel burning appliances in the same room, more ventilation
may be required.
Location of Hotplate
The hotplate may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
NOTE:
An appliance for use on LPG shall not be installed in
a room or internal space below ground level. e.g. in a
basement.
This appliance is designed for domestic cooking only.
Use for any other purpose could invalidate any warranty
or liability claim.
Positioning the Cooker
The diagrams below show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The hotplate surround should be level with, or above, any
adjacent work surface. Above hotplate level a gap of 75mm
should be left between each side of the cooker and any
adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 650mm is required between the top of
the hotplate and a horizontal combustible surface.
*Any cooker hood should be installed in accordance with
the hood man u fac tur er’s instructions.
Surfaces of furniture and walls at the sides and rear of
the appliance should be heat, splash and steam resistant.
Certain types of vinyl or laminate kitchen furniture are
