50
English
Do not use the door handles or control knobs to manoeuvre
the cooker. Use the hotplate and griddle bowl areas.
Conversion
If the appliance is to be converted to another gas do the
conversion at this point. See the conversion instructions
supplied with the conversion kit.
Levelling
You are recommended to use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker. Turn
clockwise to raise the cooker and anticlockwise to lower.
When you are satisfi ed with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the fl oor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the
front roller, to prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle of
the tool facing the rear of the cooker, so that the customer
can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push in.
Fit the Handles
Remove the 4mm Allen screws from the doors with the
hexagon key tool. Use the screws to fi t the door handles.
The handles should be above the fi xings.
Remove the 4mm Allen screws from the top corners of the
fascia and fi x the front handrail in position.
Fitting the splash back (optional)
Remove the two fi xing screws (3mm hexagonal socket
head) and nuts that pass through the top of the rear fl ue
grille. Hold the splash back in position. From the rear refi t
the 2 fi xing screws and nuts.
Gas Connection
Restraining device
A restraining device should be fi tted when the cooker is
connected to a fl exible gas supply. Any restraining device
should be secured to the fabric of the building and should
be able to be released so that the cooker can be pulled out
for cleaning and maintenance.
Flexible Gas Hose
A gas shut off valve must be fi tted between the gas supply
and the connection hose. The fl exible hose (not supplied
with the cooker) must be in accordance with the relevant
standards. If in doubt contact, your supplier.
The inlet connection on the cooker is ISO 7-1 internal. If
you require a ISO 228-1 connection fi nd the ISO 7-1 to ISO
228-1 connector in the conversion kit. Apply a suitable
thread sealing compound to the ISO 7-1 end.
Screw the connector into the cooker inlet until it is
fi nger tight. Using two suitable tools, one on the inlet
on the cooker to make sure it is held steady and one on
the connector, tighten the connector into the inlet on
the cooker.Minimum torque 15Nm.Maximum torque
20NmConnect the hose to the connector.
The hose should be fi tted so that both inlet and outlet
connections are vertical so that the hose hangs downwards
in a ‘U’ shape.
