3.4. Deleting device from a pair of controller buttons on the controller (DELETE function)
This function deletes from controller's memory the device associated with a pair of buttons on a
selected channel. However, it does not remove the device form the “Z-Wave” network. This function is
accessible from PRIMARY and SECONDARY controllers. The procedure of device deleting form a pair of
controller buttons is presented in
Figure 5
.
*) Programming error can be caused by:
•
failure to press programming button within 10 seconds from controller signaling its readiness for
deleting the device from selected pair of buttons;
•
long distance between the controller and device.
12.06.01 NC811-GB
8/16
©2012,
FAKRO
Fig. 5: Deleting device from a pair of buttons on the controllers
4.
Press “P” button on the device and hold
it for 0.5 sec. (see Device Programming
Manual).
2
. Within 1.5 sec., press:
- “
In/Ex
”(
1
) button twice and then
- the button from this pair of buttons
which operates the device to be
removed (e.g.
2
).
6*
. Programming error –
LEDs flashing for app. 2-3
sec.).
1
. Select remote control channel
through which the device to be
removed is operated.
5
. The controller is signalizing
successful device deleting (three
LEDs on for app. 2-3 sec.).
3
. The controller is signalising
readiness for device deleting (three
LEDs on for 10 sec.).
x1
Note!!!
In the new version of the controller, stopping of any procedure is possible by pressing of „IN/EX” buttons. In
older version, it is necessary to wait 10 sec. until the moment of signalling the error by the controller or resetting it by
removing the batteries.
