3.2. Associating device with a pair of buttons on the controller (ASSOCIATE function)
Associating the device with a pair of buttons on the controller, which has been already included in
the Z-Wave network according to section 3.1, makes it possible to operate the device. This procedure can be
carried out on the primary and secondary controllers. The procedure of associating the device with buttons is
presented in
Figure 3
.
*) Programming error can be caused by:
•
no button being pressed within 10 seconds from the controller signaling its readiness for associating a
new device with the network;
•
long distance between the controller and device being added;
•
device already belongs to another network or it has not been associated with any network. It is necessary
to perform EXCLUDE function on the device and repeat INCLUDE and ASSOCIATE functions.
12.06.01 NC811-GB
6/16
©2012,
FAKRO
Figure 3: Device associating with selected pair of buttons on controller
3
. The controller is signilizing
readiness for associating the
device with a pair of buttons on
the controller (three LEDs on for
10 sec.).
5
. The controller is signalizing that the
device has been successfully associated
(LEDs on for app. 2-3 sec.).
1
. Select channel on the
controller through which the
device will be operated.
6*
. Programming error –
LEDs flashing for app. 2-3
sec.
2
. Within 1 sec. press:
- “
In/Ex
” (
1
) button once and
then
- the button from this pair pf
buttons which will operate the
device (e.g.
2
).
4.
Press “P” button on the device and
hold it for 0.5 sec. (see Device
Programming Manual).
x1
Note!!!
In the new version of the controller, stopping of any procedure is possible by pressing of „IN/EX” buttons. In
older version, it is necessary to wait 10 sec. until the moment of signalling the error by the controller or resetting it by
removing the batteries.
