3.1. Adding device to network (INCLUDE function)
Adding a device to the “Z-Wave” network is possible only via “PRIMARY” controller (every
single brand new controller is set as a primary controller by default). In each network, there is always only one
primary controller and any other added to it is identified as “SECONDARY”. The procedure of device adding
to the network is presented in
Figure 2.
*) Programming error can be caused by:
•
no button being pressed within 10 seconds from the controller signaling its readiness for adding a new
device to the network;
•
long distance between the controller and device being added;
•
the device already belonging to other network. It is necessary to use EXCLUDE function and repeat the
procedure of device adding to the network.
12.06.01 NC811-GB
5/16
©2012,
FAKRO
Figure 2: Adding device to Z-Wave network
5*
. Programming error – two external
diodes flashing for app. 2-3 sec.
4
. The controller is signalizing that
the device has been successfully
added to the network (middle
LEDs on for app. 2-3sec.)
1
. Press “
In/Ex
” button once
2
. The controller is signalizing its
readiness for adding a new device
to the network (external LEDs on
for 10 sec.)
3.
Press “P” button on the device
and hold it for 0.5 sec. (see
Installation Manual).
x1
Note !!!
In the new version of the controller, stopping of each procedure is possible by pressing of „IN/EX” buttons. In
the older version, it is necessary to wait 10 sec. until the moment of signalling the error by the controller or resetting it
by removing batteries.
