26
EndURancE 50F
POT FRAME REMOvAL
NOTE: Acorn nuts must be used to protect threads
from build up.
Use a 7/16" wrench to remove acorn nuts and hex
nuts that hold the pot in heat exchanger. Insure
mating surfaces are clean prior to re-installation.
1. Remove pot parts as shown in previous 2 pages (Steps 6
thru 11).
2. Remove Igniter access Panel, shown in Figure 2 on page 5.
Then remove three screws from flange as shown in Figure
22. When removing the screws take care not to drop the
screws between the panels of the unit. Remove wire con-
nectors and carefully remove Igniter and Tube assembly as
shown in Figure 23.
3. Remove two lower acorn nuts and hex nuts carefully. Then
remove upper acorn nuts and hex nuts carefully.
4. Lower pot down and out through the ash pan opening.
Installation of Pot Frame
Reverse of steps 1 thru 4 above.
Figure 22
Figure 24
Figure 23
CAUTION
Pot is heavy, so care should be taken when
removing last nut.
POT FRAME REMOvAL
NOTE: Recommended torque for Burn Pot hex and
acorn nuts is 6 lb.-ft. Over torquing can result in
broken studs.
