14
OPERATING INSTRUCTIONS
EndURancE 50F
OPERATING INSTRUCTIONS
1. carefully read this “Installation and Operation” manual in
its entirety before starting your furnace for the first time.
2. Obtain final inspection and approval of installation from
local building officials.
3. Have your dealer demonstrate all the operational and main-
tenance steps necessary for proper use of the furnace. Sign
and return the warranty card to the address listed on the
back page.
4. Some odors may be given off during the first few hours of
burning during initial break-in. These odors are normal and
not harmful. However, ventilating the room until the odors
disappear is recommended.
5. The furnace will become hot while in operation. Keep chil-
dren, clothing and furniture away from all hot surfaces.
WARNING: Direct contact with the furnace fire chamber
during operation may cause severe burns to a person’s
skin.
Follow These Operating Instructions Exactly as Stated to Ensure Safe and
Reliable Operation.
If you have difficulty adjusting the 50F furnace, contact your dealer or technical support.
6. To avoid the possibilities of smoke and/or spark entering the
room, always keep fire chamber door and ash pan drawer
secured whenever the furnace is operating.
7. a certain amount of carbon monoxide may be produced
within the furnace as a by-product of combustion. all
exhaust vent connections must be sealed with high tem-
perature silicone to assure an air tight seal. any leaks into
a confined area caused by faulty installation or improper
operation of the furnace could produce dizziness, nausea,
and in extreme cases, death.
8. Smoke detectors installed in the same general area as the
furnace, may be activated if the furnace fire chamber door
is left open and smoke is allowed to enter the area.
Proper installation is essential for safety, effective operation, warranty coverage, insurance requirements and
to meet local building codes. Installation requirements are described in the first section of this manual. Verify
the installation, including venting, is correct before starting the furnace for the first time.
CAUTION
• Hot surfaces
• Keep children away
• Do not touch during operation
• Never add fire starter to a hot furnace
