12
Figure 10
connecting To The Thermostat
Wiring Connections
Please read the section covering thermostat control for opera-
tion. To connect a thermostat, secure the wires from the thermo-
stat to the internal wire terminal located on the backside of the
50F Furnace control board. a certified technician should do this.
The internal terminal has been pre-wired to the control board.
NOTE: Installers must determine a neutral
location to mount the thermostat for accurate
room temperature measurements.
NOTE: For installations requiring an external
thermostat, the 50F furnace must be connected
to an approved external thermostat.
FAILURE TO FOLLOW INSTALLATION REqUIREMENTS
WILL vOID ALL WARRANTIES.
CAUTION
This unit will only operate with the hopper lid closed.
Failure may result in emission of products of com-
bustion from the hopper under certain conditions.
The hopper lid needs an adequate seal to the unit.
Do not attempt to run the unit during a power failure.
EndURancE 50F
CONNECTING TO ThE ThERMOSTAT