EN
40
6. FAULTS, ALARMS AND BREAKDOWNS
The steps to be followed in the event of a fault or operating error are described below. The possible causes
and possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve
the problem, please contact the technical service.
Do not handle electrical components, as there is a risk of death as the
components are live.
FAULT
POSSIBLE CAUSE
SOLUTION
The machine does not
come on.
There is no power supply.
Check whether the magneto-thermal circuit breaker
has been triggered.
The fuses have blown.
Call the technical service to analyse the reason why.
Main switch open.
Close switch.
The machine does not fill
with water.
Water entrance valve closed.
Open the water valve.
Rinse nozzles blocked.
Clean nozzles and check branches for build-up of
lime.
Solenoid valve filter blocked.
Call the technical service to clean the filter.
Pressostat is broken.
Call the technical service to replace the pressure
switch.
Unsatisfactory wash.
Wash distributors obstructed.
Clean distributors thoroughly.
Shortage of detergent.
Call the technical service to reset the dispenser.
Dirty filters.
Clean the filters thoroughly.
Presence of foam.
Unsuitable detergent. Call the technical service to
supply correct detergent.
Too much rinse aid. Call the technical service to reset
the dispenser.
Temperature of lower tub at 50
⁰
C / 122
⁰
F.
Thermostat faulty or incorrectly set. Call the technical
service to repair it.
Length of cycle too short for
level of dirt on dishes.
Select a longer cycle.
Water too dirty.
Drain the wash tub and fill with clean water.
Dishes and kitchenware
are not dry.
There is no rinse aid
Fill the rinse aid container.
Rinse aid low.
Call technical service to adjust dispenser.
Dishes left inside dishwasher
for too long.
When the dishwasher finishes, remove the basket
from the machine and allow to dry naturally.
Rinse temperature lower than
80
⁰
C / 176
⁰
F.
Call technical service to analyse problem.
Scratches or stains on
dishes.
Too much rinse aid.
Call technical service to adjust rinse aid dispenser.
Water too chalky.
Check water hardness and if possible run
regeneration cycle immediately.
Not enough salt in salt deposit.
Fill salt deposit where applicable.
Traces of salt in tub.
When filling the salt deposit, take care not to spill salt
in the tub.
Machine stops during
operation.
Electrical installation
overloaded.
Call technical service to modify electrical installation.
Machine protection has tripped. Reset safety device and if it trips again, call technical
service.
Summary of Contents for Evo Concept Series
Page 5: ...5 3 4 5 6 MOD A MOD B B A C D I H F E G J K L M N O P Q R E...
Page 7: ...7 MOD B...
Page 26: ...FR 26...
Page 65: ......
