Fagor CNC 8055i, Installation Manual

Page: 78 / 732

·78·
Installation manual
CNC 8055
CNC 8055i
2.
CNC 805
5 I CONFIGU
RATION
S
OFT
: V02.2
X
CNC structu
re
Protection at the connectors
It detects over-currents or short-circuits at the +5 V of the feedback of the handwheels, spindle and
probe and it issues the relevant error message.
Besides this, it also detects the 24V of the external supply at the digital outputs.
Hardware protections
The axis board installed in the CNC includes the recognition of the 24V at the inputs and outputs.
Signal adapters
The following signal adapters are available to be used with the feedback inputs.
SA-TTL-TTLD Adapter for "Non-differential TTL" to "differential TTL" signals
SA-FS-P Adapter for Fagor sinusoidal signal to Vpp signal.
Technical characteristics of the feedback inputs
Feedback inputs for the axes and spindle
Power supply consumption of +5 V 1 A (250 mA per axis).
Work levels for differential square signal (axes and spindle).
Work levels for non-differential square signal (axes and spindle).
Maximum frequency: 1000 kHz.
Maximum gap between flanks: 460 ns.
Phase difference: 90º ± 20º.
Vmax in common mode: ± 7 V.
Vmax in differential mode: ± 6 V.
Hysteresis: 0.2 V.
Maximum differential input current: 3 mA.
Maximum frequency: 400 kHz.
Maximum gap between flanks: 460 ns.
Phase difference: 90º ± 20º.
High threshold (logic level "1") V
IH
: 1,25 V < V
IH
< 7 V.
Low threshold (logic level "0") V
IL
: -7 V < V
IL
< 1 V.
Vmax: ± 7 V.
Hysteresis: 0.25 V.
Maximum differential input current: 3 mA.