Fagor CNC 8055i, Installation Manual

Page: 127 / 732

CNC 8055
CNC 8055i
S
OFT
: V02.2
X
5
·127·
MACHINE AND POWER
CONNECTION
Mains connection of the 8055 CNC’s central unit
It has a three-prong plug for mains and ground connection.
Power the central unit through a separate 110VA transformer with an output voltage between 84
V AC and 264 V AC and 50-60 Hz.
The monitor & keyboard unit must be powered with 220Vac.
Mains connection of the 8055i CNC’s central unit
The "Central Unit + Monitor" set has a three-prong male Phoenix connector with a 7.62 mm pitch.
Use an independent external power supply with the following specifications:
The central unit has a protection against overvoltage that activates at 36 V.
Power switch.
• This power switch must be mounted in such a way that it is easily accessed and at a distance
between 0.7 meters (27.5 inches) and 1.7 meters (5.5ft) off the floor.
Install this unit in the proper place.
• It is recommended, whenever possible, to install the CNC away from coolants, chemical product,
blows, etc. that could damage it.
Pin Signal and function
1 + 24 V Power supply.
2 0 V Power supply.
3 Chassis Shield.
Rated voltage 20 V minimum 30 V maximum
Ripple: 4 V
Nominal current 2 A
Current peak on power-up: 8 A