Fagor 9701, Manual

Page: 3 / 39

Section Page
INTRODUCTION
Declaration of conformity ...................................................................................... 3
Safety Conditions .................................................................................................. 4
Warranty Terms ...................................................................................................... 7
Material Returning Terms ...................................................................................... 8
Additional Remarks ............................................................................................... 9
Chapter 1CONFIGURATION
1.1 Front Panel ............................................................................................................. 1
1.2 Rear Panel .............................................................................................................. 2
1.2.1 Connectors and connections .................................................................................. 3
1.2.1.1 Connector X1 ......................................................................................................... 3
1.2.1.2 Connector X2 ......................................................................................................... 5
1.3 Dimensions and installation .................................................................................. 7
Chapter 2CONNECTION TO AC POWER AND TO THE CNC
2.1 Connection to ac power ......................................................................................... 1
2.2 Connection to the CNC .......................................................................................... 2
2.2.1 General considerations ........................................................................................... 2
2.3 Start-up ................................................................................................................... 4
2.3.1 Configuration of the work mode ............................................................................ 4
2.4 General considerations for the floppy disk unit ..................................................... 5
Chapter 3OPERATION WITH 8010/20/25/30 CNC
3.1 Errors when working with 8010/20/25/30 CNC .................................................... 2
3.2 General considerations for operation with the CNC .............................................. 3
INDEX