Fagor 8035-M, Installation Manual, Page: 129 / 470

  
Installation manual
CNC 8035
MA
CHINE PARA
METERS
Ax
is parameters
4.
(S
OFT
M: V15.3
X
)
(S
OFT
T: V16.3
X
)
·129·
STOPMOVE (P49)
The CNC considers the axis to be stopped when its movements do not exceed the value set by
STOPMOVE (P49) during the time period set by STOPTIME (P48).
STOPAOUT (P50)
This parameter is used with function G52 (move to hardstop) and it indicates the residual velocity
command supplied by the CNC to exert pressure once contact has been detected.
INPOSW2 (P51)
This parameter is used when function G50 (controlled round corner) is active.
It defines the area before the programmed coordinate where the CNC considers the axis to be in
position and goes on to execute the next block.
It should be assigned a value 10 times the value of "INPOSW"
I0TYPE (P52)
Axis machine parameter I0TYPE has two digits:
Units:
It indicates the type of Io signal (marker pulse) provided by the feedback device.
Possible values
Between 0.0001 and 99999.9999 millimeters.
Between 0.00001 and 3937.00787 inches.
Default value: 0
Possible values
It is given in D/A converter units and it admits integer values between 0 and 32767 which
corresponds to an analog command of 10V.
Default value: 0
STOPAOUT Minimum velocity command
1
- - -
3277
- - -
32767
0.3 mV.
- - -
1 V.
- - -
10 V.
This parameter is especially designed for hydraulic devices.
When using servo motors, first reduce the maximum torque of the drive by means
of an "M" function in order to prevent the motor from overheating.
i
Possible values
Between 0 and 99999.9999 degrees or millimeters.
Between 0 and 3937.00787 inches.
Default value: 0.1 mm.
Value Meaning
x0 normal I0.
x1 "A" type distance-coded I0.
x2 Type B distance-coded reference mark (only linear encoder COVS).
x3 Normal I0 (search with retraction)