Fagor 8035-M, Installation Manual

Page: 337 / 470

  
Installation manual
CNC 8035
LOGIC CNC INPUTS AND OUTPUTS
Genera
l logi
c in
puts
10.
(S
OFT
M: V15.3
X
)
(S
OFT
T: V16.3
X
)
·337·
If a block is aborted and then the RETRACE function is activated, the retraced path (backwards)
will not be the same as the one traveled forward. The two paths will not coincide either when aborting
a block while the RETRACE function is active.
ACTGAINT (M5063)
The axes and the spindle can have 3 sets of gains and accelerations.
By default, the first set is always assumed. The one indicated by the a.m.p. and s.m.p.: ACCTIME
(P18), PROGAIN (P23), DERGAIN (P24) and FFGAIN (P25).
G.m.p ACTGAINT indicates with which functions or in which work mode the third set is applied, the
one indicated by a.m.p. ACCTIMET (P92), PROGAINT (P93), DERGAINT (P94) y FFGAINT (P95),
and s.m.p. ACCTIMET (P81), PROGAINT (P82), DERGAINT (P83) and FFGAINT (P84).
The gains and accelerations can also be changed from the PLC regardless of the active operating
mode or function. To do this, use general input ACTGAINT (M5063).
ACTGAINT (M5063) = 1 The CNC assumes the third set.
SKIPCYCL (M5064)
In drilling, tapping and rigid tapping cycles of the mill model CNC, it is now possible to withdraw the
tool to the starting plane and, once there, stop the spindle.
Once the retraction has been completed, the user will have the choice to finish the hole, go to the
next one or go into tool inspection.
General logic input SKIPCYCL (M5064) is used to go on to the next hole once the retraction has
been completed.
RETRACYC (M5065)
In drilling, tapping and rigid tapping cycles of the mill model CNC, it is now possible to withdraw the
tool to the starting plane and, once there, stop the spindle.
Once the retraction has been completed, the user will have the choice to finish the hole, go to the
next one or go into tool inspection.
The PLC activates this mark and the CNC cancels it automatically once the Z axis stopped and
before beginning to retract.
SETTMEM (M5066)
PLC mark used by the OEM to activate an error during a tool change. When this mark is activated,
the CNC activates the TMINEM mark.
RESTMEM (5067)
PLC mark that allows canceling the CNC's error state. This mark is activated when the user confirms
that the tool magazine has been inspected and that everything is OK to resume work.
The change of gains and accelerations is always made at the beginning of the block.
When working in round corner (G5), the change does not take place until G07 is
programmed.