3
Subject to change without notice.
Version5_20200424
e-Sense Organic is an intelligent lighting control system based on distributed information between the sensors. The sys-
tem is optimised for large offices or similar spaces. Communication between the sensors is based on infrared light, similar
to regular remote controls. The signal from one sensor, which detects presence, is distributed via the floor to other sen
-
sors nearby. These sensors transmit the information further, but include a change to not adjust up to full light, but rather
a lower level. The distribution continues with the same effect so that the light does not unnecessarily switch on too often.
In order to secure communication between the light fittings below constraints has to be taken into consideration during
installation:
Installation height 2.7–3.7 meters.
Disctance between luminaires 1.0 – 3.0 meters.
e-Sense Organic G3
The system functions immediately after power is supplied to the luminaires. No programming is required during the installation stage.
An important and unique feature in e-Sense Organic is the ability to transfer information between sensors, without phy
-
sical interconnection. In daily use, this relates to information about presence, but, when programming the system, such
information can also be “relayed” to other luminaires.
Upon delivery, the factory settings can be used in an office
environment. The time after last presence, and followed
by low level is 10 + 10 minutes. If presence is detected
again at any time during the intervals, the time is reset.
Max. illumination is 100%.
The sensor is equipped with multiple functions. A PIR
sensor for presence detection, IR transmitter, IR receiver
and a light sensitive diode for measuring brightness. It
also has two LEDs which indicate whether a certain fun-
ction is enabled.
Relay function
Factory settings
IR Transmitter
Light Meter
IR Receiver
PIR Sensor
Green indicator
Summary of Contents for e-Sense Organic G3
Page 1: ...e Sense Organic G3...
