28
Subject to change without notice.
Version5_20200424
Infrared Transmission
Sensor Node Settings
If you suspect that the IR signal from one sensor to
another is too weak, or is not being reflected adequately,
you can perform a transmission test. Point the dongle at a
sensor node and press “Transmission Test”. The node at
which the dongle is pointed will flash red twice per second
for 15 seconds, while the receiving node will flash red for
approx. 30 seconds. If a node has poor reception, it will
only flash a few times. In such a case, it is necessary to
amplify the out signal from the node sending the com-
mands. Use the app to adjust the strength of the IR signal.
Three choices can be made from this menu:
“Save Settings” saves all settings made for a specific node
or the zone it belongs to.
"Recall settings” recalls all settings made for a specific
node or the zone it belongs to.
“Recall Factory Default Settings” resets the factory set-
tings for a node or the zone it belongs to. Factory settings
can be found earlier in this manual.
.
Summary of Contents for e-Sense Organic G3
Page 1: ...e Sense Organic G3...
