16
Fadal/Sinumerik 810D CNC: Pendant Hard Keys Function Guide
October 2000
SIEMENS CONTROL
Operator Manual
Fadal
Finding Machine Reference (Cold Start)
The FADAL machine tool has software limits and does not contain position
limit switches. Therefore, the machine tool must be physically located at
set alignment marks. The Siemens control automatically powers on in the
machine reference mode. It is recommended that the machine be shut
down at its axis alignment position to simplify the Power On procedure.
NC Cycle Start Button
Starts the execution of the CNC in Auto Mode or
operation in Manual Mode.
NC Cycle Stop Button
Stops the execution of CNC program, control waits for
NC Cycle Start signal or Reset signal.
Tool In/Out Button
Activates the drawbar to manually load or unload a tool
from the spindle. This button is active only in the Manual
Mode.
Turret CCW Button
Rotates the turret in a counterclockwise direction. This
button is active only in the Manual Mode.
Turret CW Button
Rotates the turret in the clockwise direction. This button is
active only in the Manual Mode.
Work Light Button
Toggles the machine work lights on and off.
Table 2: Machine Control Panel Keypad Hard Keys
Key
Name and Function
