26
Fadal/Sinumerik 810D CNC: Jog Modes Of Operation
October 2000
SIEMENS CONTROL
Operator Manual
Fadal
Note:
When loading a holder into the spindle, inspect the taper for chips and
dents. Remove any chips or dents from the taper with a flat stone.
Tools, Loading a Holder From the ATC
When tool holders are in the ATC (Automatic Tool Changer), they can be
loaded into the spindle by using the T,S,M mode.
1) Press the T,S,M soft key.
2) Type T# (where # is the turret location of the tool to be loaded
into the spindle).
3) Press the INPUT hard key.
4) Press the CYCLE START hard key to make the exchange.
Note:
If the feed rate potentiometer is set to 0%, no motion will occur when the
START button is pressed.
CAUTION:
If the tool change is interrupted, the selected tool becomes a null value
and the machine will try to load a tool. If this occurs, remove the tool from
the spindle and repeat the operation.
Active Tool Number
