24
www.factorelectronics.com
HDBaseT-4x4Matrix
Factor Electronics
Once you have obtained an RMA number by contacting Factor at
[email protected]
After obtaining an RMA number from Factor Electronics, you must send the product - freight
prepaid - to Factor ElectronicsTheFactor Electronics RMA number must be prominently displayed
on the outside of your package. If you send your product to Factor Electronics without the RMA
number prominently displayed on the outside of the package, it will be returned to you unopened.
Please use a shipping company that can demonstrate proof of delivery. Factor Electronics does not
accept responsibility for any lost shipments unless proof of delivery to Factor Electronics is
provided.
Please note
Product shipped to Factor Electronics must be properly packaged to prevent loss or damage in
transit.
Shipping your RMA to Factor Electronics using regular mailing envelopes is not acceptable, as they
do not protect the product from damage during shipping.
Factor Electronics will not repair or replace a module that is shipped in such a way that the product
is not properly protected.
Factor Electronics will not accept any product that has been damaged as a result of accident,
abuse, misuse, natural or personal disaster, or any unauthorized disassemble, repair or
modification.
1
www.factorelectronics.com
HDBaseT-4x4Matrix
Factor Electronics
Thank you for purchasing this product. For optimum performance and safety, please read these
instructions carefully before connecting, operating or adjusting this product. Please keep this
manual for future reference.
SURGE PROTECTION DEVICE RECOMMENDED
This product contains sensitive electrical components that may be damaged by electrical spikes,
surges, electric shock, lightning strikes, etc. Use of surge protection systems is highly
recommended in order to protect and extend the life of your equipment.
SAFTY NOTICE
1. The transmission distances of HDMI over UTP cables are measured using TE CONNECTIVITY
1427071-6
2.
EIA/TIA-568-B termination (T568B) for CAT cables is recommended for better performance.
3. DO NOT use 568A/568B standard mixed CAT cable (cross-over cable) because there are 2
pairs swapped, this will make POE OVER-CURRENT and damage POE components. Please
use straight-through CAT cable (both RJ45 headers are 568A or 568B standard).
4. It is recommended that power up the device after connections of source, sink and CAT cable.
5. To reduce the interference among the unshielded twisted pairs of wires in CAT cable, do not
run HDBaseT / Zone Cat5e/6/6a cabling with or in close parallel proximity to mains power
cables. Shielded CAT cables can be used to improve EMI problems, which is worsen in long
transmission.
6. Because the quality of the CAT cables has the major effect on how long the transmission limit
can achieve and how good is the received picture quality, the actual transmission range is
subject to one‟s choice of CAT cables.
7. Do not substitute or use any other Power Supply other than the enclosed unit, or a Factor
Electronics approved Replacement Part. Doing so will void the warranty and potentially expose
the user to dangerous voltages resulting in an electrical shock.
8. Do not disassemble the device
for any reason. Doing so will void the manufacturer‟s warranty.
Also, our unique case is an integral part of the design of this unit and is responsible for cooling
and circuitry shielding. Any modifications to this case will potentially cause malfunction and
product failure.
9. Do not expose the device to water, moisture, or liquids. Possible electric shock may result as
well as failure of the unit to operate.
Summary of Contents for HDBaseT
Page 2: ......
