ENGLISH
25
BEHAVIOUR
REASON
SOLUTION
ON ACTIVATION, THE MOTOR DOES NOT
PERFORM ANY MOVEMENT
Travel limits already set
If you wish to modify the travel limits, execute a reset
as indicated in chapter 6 and perform a new learning
operation (chpt.5)
THE MOTOR HAS TRAVEL LIMITS ALREADY
SET, BUT IT DOES NOT ACCEPT COMMANDS
COMING FROM THE REMOTE CONTROL
Sun sensor
activated
Disable the sun sensor
Remote control has lost
memory
On the remote control, perform the memory storing
procedure for the first remote control
If there are not other remote controls, perform total deletion
of the memory and the memory storing operation of the
single remote control.
If there are other remote controls operating , perform
the procedure to add remote controls, thus memory
store it again
THE TRAVEL LIMITS LEARNING PROCEDURE
CANNOT BE COMPLETED
Incorrect sequence of
commands sent
Execute the travel limits reset to return the motor to the
factory-set parameters.
(the remote controls do not lose memory)
THE MOTOR WITHOUT SET TRAVEL LIMITS
DOES NOT ACCEPT COMMANDS COMING
FROM THE REMOTE CONTROL
Remote control
not memory stored
Memory store the first remote control
A NEW REMOTE CONTROL CANNOT BE
ADDED
The maximum number of
remote controls that can be
memory stored has been
exceeded (Max 20)
Delete an old remote control and memory store again
a new one
EVERY TIME THE MOTOR IS SUPPLIED
WITH POWER, IT PERFORMS THREE BRIEF
MOVEMENTS IN BOTH DIRECTIONS
The motor is in advanced
menu mode
Exit the advanced menu holding down the stop/preferred
position push-button for 7 seconds
AT THE END OF PROGRAMMING, IF
YOU PRESS THE DOWN PUSH-BUTTON
THE ROLLING SHUTTER RISES (AND VICE
VERSA)
The setting sequence of the
travel limits was exchanged
• Perform a Reset and repeat the correct travel limit
setting procedure.
IN ROLLING SHUTTER MODE THE
MOTOR REVERSES MOTION DURING
DOWNSTROKE
Friction during motion
• Clean the guides
• In the advanced menu select a suitable
detection sensitivity for the application
• Enter the advanced menu and “disable” the
obstacle detection in the critical area.
IN ROLLING SHUTTER MODE THE MOTOR
DOES NOT DETECT THE OBSTACLE
Setting error
• The obstacle detection sensor has not been
fitted (only for 45 and 58 mm). Fit the obstacle
detection sensor
• Make sure you have set the rolling shutter mode.
