![FAAC T-MODE TM 35 ER Manual Download Page 23](http://html1.mh-extra.com/html/faac/t-mode-tm-35-er/t-mode-tm-35-er_manual_3117918023.webp)
P
X 3
X 1
X 1
X 4
P
X 4
ENGLISH
23
x N times
1 Pressing of down push-button = Obstacle detection not active
....2,3,4,5,6,7,8,9 Pressings of down push-button
9 Pressing of down push-button = Maximum obstacle detection sensitivity
4 seconds
WITHIN 1 SECOND
Every pressing 2 seconds
Every pressing
2 seconds
9.3.2 MODIFYING THE POSITION OF OBSTACLE DETECTION END
DETECTION
END AREA
You can modify the position of the obstacle detection end.
In this area, if an obstacle is present, the motor does not reverse movement but continues to operate until reaching
the down travel limit
1) Take the rolling shutter up to the point where an obstacle detection inhibition is required (You can also set the whole
rolling shutter travel)
2) Press the programming push-button four times
3) The motor performs three brief movements to confirm you have entered the advanced menu
4) Press and hold down the down push-button until the motor performs 2 brief movements in both directions to confirm
the performed setting of the position and the exit from the advanced menu.
6) If the motor performs three brief movements in both directions, this means that the procedure was not performed
correctly and that you are still in the advanced menu. Repeat point 4.
Press the programming push-button four times (every pressing should last 2 s
and the interval between two pressings should be of approx. 1 second)
Take the rolling shutter to the
point where you require a high
sensitivity.
every pressing
2 seconds