![background image](http://html.mh-extra.com/html/faac/531em/531em_manual_535477007.webp)
20
6.3. OUTSIDE RELEASE DEVICE (optional)
When using the outside release device, fit the cable in the
seat before starting installation.
1) Release the carriage (see par. 7.4. point 3) and bring it to
the slot located on the upper part of the sliding guide.
2) Insert the cable end in the special red seat (fig. 10).
3) Move the carriage back towards the drive coupling unit
until the through hole on the carriage matches the slot and
insert the unsheathed cable (fig. 11).
4) Pull the cable out from the bottom part of the carriage.
5) Wind the cable around so that it is not a hindrance when
installing the sliding guide.
Fig. 13
7.1. SLIDING GUIDE
After completing the preliminary assembly operations, install
the sliding guide, proceeding as follows:
1) Draw a vertical line on the lintel, corresponding to the
centre of the door (fig. 12).
2) Draw a horizontal line on the lintel, corresponding to the
max. height reached by the door during movement (see
fig. 4).
3) Position the front connection fixing bracket with bottom
edge at least 5 mm above the intersection point of the
lines and centred with the vertical line (fig. 12). See par.
7.2. for correct positioning of the bracket with respect to
the connection point on the door.
4) Mark the two fixing points.
5) Drill the holes and proceed with installation.
6) Position the sliding guide on the ground, perpendicular to
the door.
7) Lift the guide from the front connection and assemble the
connection with the fixing bracket using the special through
screw and nut (fig. 13).
7. INSTALLATION
To ensure you work in safe conditions, we advise you to install
the operator while keeping the door fully closed.
Use the specified anchorage points.
The fastening systems must be suitable for the type of support
and sufficiently tough.
Protect your hands and face adequately while drilling the holes.
Read this chapter to the full before you begin installing.
Fig. 10
Fig. 12
Fig. 11