4
Technical Data
The 412 Compact Operator
Parameter Measure
Voltage required
1
, VAC
115, +6 or -10%, 50
−
60 Hz
230, +6 or
−
10%, 50
−
60 Hz
Duty type
Residential duty
Maximum duty cycle
2
18 cycles/hr
30 cycles/hr
Maximum leaf length, ft (m)
14 (4.3)g
Maximum leaf swing, deg
110
Thrust and traction
3
, ft-lb (Nm)
0
−
294 (0
−
400) 0
−
235 (0
−
320)
Stroke, in. (cm)
11 3/8 (29)
Rod speed
4
, in./sec (cm/sec)
3/4 (1.9)
5/8 (1.6)
Thermal cut out, deg F (deg C)
284 (140)
Operator dimensions,
l
×
w
×
h, in. (cm)
39 5/16
×
3 3/4
×
7 9/16
(99.8
×
9.5
×
19.2)
Operator weight, lb (kg)
14.3 (6.5)
Current draw, A
5
2
Maximum amperage draw for
accessories, mA
300 360
1
Your standard 220 VAC power supply meets the specification for 230 VAC,
+
6 or
−
10%
2
While the 412 Operator is capable of 18 or 30 cycles/hr, as a residential-duty operator it is not designed for
such continuous, sustained operation.
3
Additional torque may be available for heavier gate leaves if you change capacitors. Call our Technical
Department. Note that any change in the capacitors may affect duty cycle.
4
The 90-deg opening time for a gate with the 412 Operator is a maximum of about 46 sec. Note that both the
mounting dimensions and the torque adjustment help to determine the precise opening speed.
The Control Panel
The 450 MPS control panel is installed with the 412
Compact Operator. Both the control panel and the
operator must use the same power supply voltage.
To determine the voltage requirement of your operator,
look at the label on the operator. To determine the
voltage requirement of your 450 MPS control panel,
refer to the label on the transformer of the control panel.
The control panel allows you to set these parameters:
•
The closing leaf delay for a two leaf gate
system (note the opening leaf delay is fixed at
2.5 sec)
•
The opening/closing time
•
The pause time
•
The torque
•
The operating logic for your gate system
•
The reversing stroke function of the operator
•
The behavior of triggered reversing devices
Power source
: Use the power source that matches both
the operator and the control panel.
Note that your standard 220 VAC power source meets
the specification for 230 VAC (+6 or
−
10%, 50
−
60 Hz).
Operating logics available
: A, S, E, EP, B, and C.