TM2
X
W
20
A4518_6H02_Rev.A
The base is attached to the terminal bar with M4 screws
(not included) or the double-sided adhesive already
found on the back. Inside of the base, there is an arrow
that enables the identification of the proper direction for assembly
of the sensor: put arrow upwards.
The sensor must be assembled parallel with the end bar.
Attention: do not insert the sensor inside of the end bar profile
but install the sensor
on the
internal side
of the end bar, at the end closest to the motor or to the control
unit or in any event within 10 metres.
INSTALLATION
The sensor is housed in a plastic container made
up of two parts: a base attached to the terminal
bar and a snap-on shell.
The shell contains the sensor processor board,
the battery compartment and the programming
commands.
Best Position:
internal side
of the bar.
Make sure that there is enough space and TM2 X W does not get damaged by closing
the awning!
YES
max 10 m
YES
NO
BATTERY COMPARTMENT
BASE
SET BUTTON
LED
SELECTOR
SHELL
EN
Summary of Contents for 145503
Page 1: ...TM2 XW ...
