EN
112
5.
TECHNICAL SPECIFICATIONS
5.1 Wheels
Mounting using a quick-release mechanism
Release the quick-release lever, slide it into the wheel axle, tighten the adjusting cap located on the
opposite end of the axle, and loosen it by one turn. The safety washers must always rest on the fork blades
and the quick-release system. Mount the wheel, center it, and lock the lever firmly by hand. The lever is
firmly fixed when it reaches a position parallel to the fork.
HINT:
You should feel strong resistance when you press the quick release lever: this means that the wheel
is mounted correctly. Press the front wheel by hand to make sure it is firmly mounted.
1. Adjusting cap
2. Quick release lever
3. Lever secured position
4. Safety washer
5. Lever released position
6. Fork jaws
7. Nut
8. Hub
9. Safety washer
Mounting with no quick-release mechanism
Mount the wheel, center it and tighten the nuts on each side of the fork. The safety washers must always
rest on the fork blades and the hub nuts. Tightening torque: 17 Nm.
Before use, make sure that your wheels are properly secured to the frame and fork.
5.2 Pedals
Your pedals are marked with the letters
“R” and “L”. When fitting, turn the right pedal, marked “R”, on the
right side of the crank (also marked “R”) on the crank plate face. Turn tight by turning clockwise toward the
front wheel. Turn the left pedal marked “L” to the left crank “L” to the fron
t wheel in a counterclockwise
direction. Tighten both pedals well!
5.3 Handlebars
Some models allow you to adjust the handlebars by changing the depth of the stem. Loosen the handlebar screw
to select the desired height, then tighten the screw at the top of the stem. Recommended handlebars tightening
torque: 17 Nm. Stem screw minimum breaking point: 26 Nm.
Note:
Some handlebar headsets cannot be adjusted.
Summary of Contents for E-Moon Trek 28 Series
Page 4: ......
