EZ-GO 606420-FI, Owner'S Manual And Service Manual

Page: 44 / 134

OPERATION AND SERVICE INFORMATION
Page 26
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
WIRING
3
Check all wiring for loose connections and broken/missing insulation
ACCELERATOR CABLE
3
Check for smooth movement - DO NOT LUBRICATE CABLE
CHOKE CABLE
3
Check for smooth movement and adjustment - DO NOT LUBRICATE CABLE
CARBURETOR LINKAGE
3
Check attachment, adjust as required
DIRECTION SELECTOR
3
Check for smooth movement and attachment, adjust as required
STARTER/GENERATOR BELT
3
Check for tension, wear and cracks
STEERING ASSEMBLY
3
Check for abnormal play, tightness of all hardware
TIE RODS/LINKAGES
3
Check for excessive play, bent components or loose connections
REAR AXLE
3
Check for leakage, add SAE 30 oil as required
50 HOURS
(includes items listed in previous tables & the following)
ENGINE
S
Change oil, DO NOT OVERFILL (See Notes 1 and 2 on page 27)
3
Check spark plug wires for cracks/loose connections
EXHAUST
3
Inspect/clean spark arrestor
FRONT AXLE
3
Check for damage to axle and loose or missing hardware
FRONT SHOCK ABSORBERS
3
Check for oil leakage and loose fasteners
FRONT SPRINGS
3
Check for loose hardware, cracks at attachments
FRONT WHEEL ALIGNMENT
3
Check for unusual tire wear, align as required. See FRONT SUSPENSION AND
STEERING section
PARKING BRAKE
3
Check for binding cables
3
Check for damage or wear
Œ
Lubricate, use light oil. DO NOT LUBRICATE CABLES
HYDRAULIC BRAKE FLUID
3
Check level, add if required (DOT 3) and check for leakage
REAR SHOCK ABSORBERS
3
Check for oil leakage, loose mounting hardware
FUEL SYSTEM
3
Check for leaks at tank, cap, lines, filter, pump and carburetor
3
Check fuel lines for cracks/deterioration
THROTTLE/GOVERNOR LINKAGE
3
Check operation and governed speed
100 HOURS
(includes items listed in previous tables & the following)
ENGINE
S
Change oil filter (See Note 1 on Page 27)
S
Change air cleaner cartridge if damaged or dirty (See Note 3 on Page 27)
DIRECTION SELECTOR
3
Check for wear and smooth movement (lubricate shaft with light oil if required)
3
Check shift cable spring length
KING PINS
3
Check for excessive play and tightness of retaining nuts
Œ
Lubricate, use wheel bearing grease
STEERING ASSEMBLY
Œ
Lubricate linkage, use wheel bearing grease
TIE RODS/LINKAGES
Œ
Lubricate, use wheel bearing grease
REAR AXLE
3
Check for unusual noise and loose missing mounting hardware