5-1-9 Connecting air tubing
1) Prepare an air compressor.
*Prepare an air compressor that satisfies the following
performance.
• Control pressure: 3.5kg/cm
2
or more
•
・
Discharge air volume: 25L/minor more
2) Squeeze the tube in the air piping connecting port until
it hits the back for connection.
*Slightly pull the tube to check it is not pulled.
*The length of air piping tube is 10m.
Install the air compressor in the position where the
tube reaches it.
3)Connect the unconnected air piping tube to the
compressor.
*If you use an air compressor other than the optional
product, change the connecting port to the one to
which OD 6mm air piping tube can connect.
(Recommendation: Tube fitting made by PISCO)
*When you remove the air piping tube, pull out the tube
while pushing the rim of connecting port.
Air connecting port
Air piping tube
①
Push the rim
②
Pull out tube
[How to remove tube]
-16-
5-1-10 Connecting recorder cable
Connecting to the recorder allows you to record data
on the inlet temperature, outlet temperature and
dry air volume.
1) Connect the banana plug side of cable for recorder
(supplied with the product) to terminal area in the
same color of recorder output terminal on the left
side of the product.
*The cable for recorder is the same for all outputs.
2) Connect a red line of Y-terminal in cable for
recorder to + terminal of the recorder and a black
line to - terminal, respectively.
*Output to recorder
Recorder output terminals
Rim
Inlet
temperature(Upper
rack)
:
50~250°C
→
0~10mV
Output
temperature(Middle
rack:):
50~250°C
→
0~10mV
Dry air volume(Lower
rack):
0.0~1.0 m
3
/min
→
0~10mV