Extron electronics VGA MATRIX SWITCHERS MVX PLUS 128, User Manual

Page: 76 / 148

SIS
™
Programming and Control, cont’d
MVX Plus 128 VGA Matrix Switchers • Programmer’s Guide
4-6
PRELIMINAR
Y
Command/Response Table for SIS Commands
Symbol defi nitions
]
= CR/LF (carriage return/line feed) (hex 0D 0A)
}
= Carriage return (no line feed, hex 0D)
(use the pipe character,
|
, instead for Web browser commands)
• = Space character
|
= Pipe (vertical bar) character
E
= Escape key (hex 1B)
(use W instead of Esc for Web browsers)
X!
= Input number 01 – 12
X@
= Input number (for tie) 00 – 12 (00 = untied)
X#
= Output number 01 – 08
X$
= Numeric dB value –18 to +24 (45 steps of gain or attenuation)
X%
= Audio gain 0 – 24 (1 dB/step)
X^
= Audio attenuation 1 – 18 (1 dB/step)
X&
= Volume adjustment range 0 – 64 (1 dB/step except for 0-to-1, which is 34 dB)
(see the table on page 4-9)
X*
= Room # (for room presets) 10 max. (each can have up to 10 presets (
X1@
s) assigned)
N A Room is a subset of operator-selected outputs that relate to each other. The MVX Plus 128 switcher supports up to 10 rooms , each of
which can consist of from 1 to 16 outputs.
X(
= Mute, executive mode, power supply (0 = off/not OK, 1 = on/OK)
X1)
= Group # (for I/O grouping) 1 through 4 groups (0 = no group)
X1!
= Global preset # 32 maximum (0 = current confi guration)
X1@
= Room preset # 10 maximum (0 = current confi guration for room)
N
A Room preset is a stored confi guration with all of the outputs assigned to a single room . When a room preset is retrieved from memory,
it becomes the current confi guration.
X1#
= RGB delay interval Delay in ½ second increments (10 maximum)
X1$
= Video/audio mute: 0 = no mutes
1 = video mute
2 = audio mute
3 = video and audio mute
X1%
= Sync frequency xxx.xx (frequency in Hz (V) or kHz (H))
X1(
= Firmware version number to second decimal place ( x . xx )
X2)
= Verbose fi rmware version-description-upload date/time. See page 4-15.
X2#
= Name 12 characters maximum for global and room preset names
11 characters maximum for room names
Upper- and lower-case alphanumeric characters and
_ : = / and spaces are valid.
N
The following characters are invalid in the name: {space} ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
X2$
= Voltage Positive or negative voltage and magnitude
X2%
= Temperature Degrees Fahrenheit