5-7
MVX Plus 128 VGA Matrix Switchers • Matrix Software
PRELIMINAR
Y
N
When the control program is connected to the switcher via the RS-232 link, the
Administrator and User Password fi elds are not masked. If a password has been
inadvertently changed to an unknown value, you can look up and, if desired,
change a password in this window without knowing the current password.
Matrix IP Address fi eld
The Matrix IP Address fi eld contains the IP address of the connected matrix
switcher. This value is encoded in the fl ash memory in the switcher.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfi elds, properly called
octets, separated by dots (periods). Each fi eld can be numbered from 000 through
255. Leading zeroes, up to 3 digits total per fi eld, are optional. Values of 256 and
above are invalid.
The default address is 192.168.254.254, but if this confl icts with other equipment at
your installation, you can change the IP address to any valid value.
N
Editing the Extron IP address while connected via the Ethernet port can
immediately disconnect the user from the matrix switcher. Extron recommends
editing this fi eld using the RS-232/RS-422 link and protecting the Ethernet
access to this screen by assigning an administrator’s password to qualifi ed and
knowledgeable personnel only.
Edit this fi eld as follows:
1
.
Click in the Matrix IP address fi eld. The graphic cursor becomes a text cursor.
2
.
Edit the address as desired.
3
.
Press the Tab key on the keyboard or click in another fi eld to exit the Matrix IP
Address fi eld.
4
. Click
the
Take
button to make the address change take affect.
Extron Name/Descriptor fi eld
The Extron Name/Descriptor fi eld contains the name used as the “from”
information when the MVX Plus 128 switcher e-mails notifi cation of its failed
or repaired status. This descriptor can be changed to any valid name, up to 12
alphanumeric characters.
N
The following characters are invalid in the Extron Name/Descriptor fi eld:
{space} + ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
Edit this fi eld as follows:
1
.
Click in the Extron name/descriptor fi eld. The graphic cursor becomes a text
cursor.
2
.
Edit the name as desired.
3
.
Press the Tab key on the keyboard or click in another fi eld to exit the Extron
Name/Descriptor fi eld.
4
. Click
the
Take
button to make the name change take effect.
