Extron electronics NAV E 101, User Manual

Page: 20 / 80

NAV E 501 and NAV E 101 Encoders • Installation and Basic Operation 12
D
NAV LEDs (see figure 8 on page 11) — Indicate the output status of the AV and USB
(NAV E 501 only) streams, as follows:
Stream LED
•
Lit steadily
– The encoder is actively streaming a NAV output consisting of video,
audio, or both to one or more NAV decoders.
•
Blinking – The encoder is actively streaming a NAV output, but network errors are
present.
• Unlit - The encoder is not actively streaming a NAV output.
USB (NAV E 501 only)
•
Lit steadily
– The encoder is actively sending and receiving a NAV USB stream.
•
Blinking – The encoder is unable to establish a NAV USB stream.
• Unlit — The encoder is not actively sending and receiving a NAV USB stream.
E
USB LEDs (NAV E 501 only)— Indicates the status of the USB stream, as follows:
Host
•
Lit steadily – The encoder is in USB host mode, the default condition.
• Unlit – The encoder is in USB device mode.
NOTES:
•
You can tie a USB host only to a USB device for proper system operation.
• If you connect a host, such as a PC, to an endpoint that is in USB device
mode, the endpoint cannot recognize the device.
Active
• Lit steadily – A host or USB device is connected to the rear panel USB port.
•
Unlit – No host or USB device is connected to the rear panel USB port.
• Blinking – A USB device or hub is connected to the encoder and is drawing more
power than the USB port can supply.
F
LAN LEDs — Indicate the status of the network connections, as follows:
NAV LEDs (NAV E 501) or LAN LED (NAV E 101) —
Link LED — Indicates the status of the link.
• Lit steadily — Indicates that a network link is established at 1 Gbps.
• Blinking – Indicates that network link is established less than 1 Gbps.
Act LED — Indicates the rate of network traffic. The blink rate corresponds to
activity.
Ext LEDs (NAV E 501 only) —
Link LED — Indicates the status of the link.
• Lit steadily — Indicates that a network link is established.
• Blinking – Indicates that network link is established less than 1 Gbps.
Act LED — Indicates the rate of network traffic. The blink rate corresponds to
activity.
G
ID button and LED — The recessed ID button identifies the encoder to the network
when pressed. The LED blinks when the encoder is in pairing mode and lights when it is
paired or device identification is selected from the encoder or NAVigator HTML page.