Extron electronics NAV E 101, User Manual

Page: 46 / 80

NAV E 501 and NAV E 101 Encoders • HTML Operation 38
2. Select (click) a reset level (see figure 35 ,
2
on page 37) or Reboot (
3
).
NOTES:
• Reset Device Settings (Retains TCP/IP Settings and Password)
—
Resets configuration settings. All communication settings and the password
are retained. See the
table
of communication and configuration settings on
page 35.
• Reset All Settings and Delete Files (Retains TCP/IP Settings) —
Resets configuration settings except the communication settings, which are
maintained. Resets the password to the default, which is
extron
. See the
table of communication and configuration settings.
• Reset All Settings and Delete Files — This reset is identical to the Mode 5
reset (see the table of rear panel reset modes on page 15), which resets all
settings to factory defaults.
3. Click Apply (
3
).
The encoder reports that it is
Resetting
or
Rebooting
and
displays a status bar that shows the progress of the
operation. Any of these operations concludes, with the
encoder rebooting.
NOTE: You must reconnect to the encoder (see
Opening the Embedded HTML Pages on page 16)
if you have other operations to perform.