Extron electronics NAV E 101, User Manual

Page: 19 / 80

NAV E 501 and NAV E 101 Encoders • Installation and Basic Operation 11
ATTENTION:
• Power supply voltage polarity is critical. Incorrect voltage polarity can damage the
power supply and the unit. The ridges on the side of the cord (see
figure 7 on
page 9) identify the power cord negative lead.
• La polarité de la source d’alimentation est primordiale. Une polarité incorrecte
pourrait endommager la source d’alimentation et l’unité. Les stries sur le côté du
cordon (voir
l’illustration 7 sur la page 9) permettent de repérer le pôle négatif du
cordon d’alimentation.
To verify the polarity before connection, plug in the power supply with no load and check the
output with a voltmeter.
Front Panel Features
NAV E 101
INPUTS
HDCP
HDMI
CONFIG
STREAM
LNK
ACT
ANALOG
AUDIO
HDMI AUDIO
NAV LAN ID
NAV E 501
INPUTS
HDCP
HDMI
CONFIG
USB
STREAM
ACTIVE
HOST
-LNK-
-ACT-
NAV EXT
ANALOG
AUDIO
HDMI AUDIO
NAV LAN ID USB
C C C B B B A A A D D D F F F G G G E E E
Figure 8. Encoder Front Panel Features
A
Power LED
B
Configuration port
C
Inputs LEDs
D
NAV LEDs
(see
page 12
)
E
USB LEDs (NAV E 501 only)
F
LAN LEDs
G
ID button and LED
A
Power LED — Indicates power and startup status, as follows:
•
Blinking
— The unit is receiving power, either locally or via PoE and is booting up.
•
Lit — The unit is receiving power, either locally or remotely (via PoE) and is
operational.
B
Configuration port — This USB mini-B port (USB 2.0) is used to configure the
encoder and to update firmware.
C
INPUTS LEDs — Indicate status of the signal inputs, as follows:
•
HDMI LED
— The encoder is receiving an active HDMI input signal.
•
HDCP LED — The HDMI signal is HDCP encrypted.
• HDMI Audio LED — The embedded HDMI audio input is selected.
• Analog Audio LED — The analog audio input is selected.
Lit Solid - Network link is established.
(0.5Hz) Flashing Green - Network link is
established at 100/10 Mbps.