NAV E 101 DTP Encoder • Installation and Basic Operation
12
Operation
After the encoder, all decoders, and their connected devices are fully booted up and
operational (the Power LED on each unit is lit steadily) and the devices are paired, the
system is fully operational. If any problems are encountered, ensure all cables are routed
and connected properly.
System operation with a NAVigator
Your NAV system must include an Extron NAVigator, a system manager that configures and
controls the AV streaming system. The NAVigator allows you to make changes to multiple
endpoints in the system from a central location, simplifying operations such as making ties
or bulk configuration.
The base version of the NAVigator can support up to 16 endpoints by default, but if a
LinkLicense is installed, support can be expanded to up to 240 endpoints, depending on
the LinkLicense.
See the
NAVigator User Guide
for details.
Configuration and other operations
Configuration and more complex operation of the system is accomplished via embedded
web pages (see
, beginning on page 15) or Extron Toolbelt. Simple
Instruction Set (SIS) commands (see
, starting on page 59) cannot be issued
directly to the encoder, but are issued via an Extron control system on the AV network
using a process known as “encapsulation” (see the
NAVigator User Guide
, available at
for details).
Reset Operations
The rear panel
RESET
button initiates three levels of resets (numbered 1, 4, and 5 for
comparison with an Extron IPL product). The
RESET
button is recessed, so use a pointed
stylus, ballpoint pen, or small screwdriver to access it.
See the table below for a summary of the modes.
ATTENTION:
•
Review the reset modes carefully. Using the wrong reset mode may result in
unintended loss of flash memory programming, port reassignment, or an encoder
reboot.
•
Étudier de près les différents modes de réinitialisation. Appliquer le mauvais mode
de réinitialisation peut causer une perte inattendue de la programmation de la
mémoire flash, une reconfiguration des ports ou une réinitialisation du contrôleur.
NOTES:
•
The reset modes listed in the table are separate functions, not a continuation from
mode 1 to mode 5.
•
The modes listed close all open IP and other connections and close all sockets.
