Extron electronics IN1604 DT, User Manual

Page: 17 / 86

IN1604 DTP and IN1604 HD Scalers • Installation 11
Connection Details
Analog Video Wiring
Pinout Table for 15-pin HD Connectors
Pin RGBHV RGBs Component S-video Composite
1 Red Red R-Y
2 Green Green Y Luma Video
3 Blue Blue B-Y Chroma
4
5
H Sync Return C Sync Return
6 Red Return Red Return R-Y Return
7 Green Return Green Return Y Return L Return Video Return
8 Blue Return Blue Return B-Y Return C Return
9
10 V Sync Return/
DDC Return
DDC Return
11
12
EDID/DDC EDID/DDC
1 5
11
15
13 H Sync C Sync
14 V Sync
15 EDID/DDC EDID/DDC
HDMI Connections
Use an Extron LockIt lacing bracket to secure an HDMI
cable to each device.
1. Plug the HDMI cables into the panel connection
(see
1
of the image to the right).
2. Loosen the side HDMI connection mounting screw
from the panel enough to allow the LockIt lacing
bracket to be placed over it (
2
). The screw does
not have to be removed.
3. Place the LockIt lacing bracket on the screw and
against the HDMI connector, then tighten the screw
to secure the bracket (
3
).
ATTENTION: Do not overtighten the HDMI connector mounting screw. The
shield to which it is fastened is very thin and can easily be stripped.
ATTENTION : Ne serrez pas trop la vis de montage du connecteur HDMI. Le
blindage auquel elle est attachée est très fin et peut facilement être dénudé.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt
lacing bracket (
4
).
5. While holding the connector securely
against the lacing bracket, use pliers or
a similar tool to tighten the tie wrap,
then remove any excess length.
The LockIt bracket can also be used in a
stacked formation, as shown right.
Side Mounted Stacked
1
2
3
4