Extron electronics Fiber Matrix 6400, Setup Manual

Page: 4 / 21

Refer also to the Fiber Matrix 6400 Switcher User’s Manual at www.extron.com.
Table of Contents
Chapter One • Introduction
................................................... 1-1
About this Manual
.................................................................... 1-2
About the Fiber Matrix 6400 Switchers
............................. 1-2
Configurability and transmission modes ............................. 1-4
Chapter Two • Installation
...................................................... 2-1
Rear Panel
.................................................................................... 2-2
A note on I/O boards ............................................................. 2-2
Making connections ............................................................... 2-4
Front Panel
................................................................................... 2-6
Chapter Three • Front Panel Operation
.......................... 3-1
Creating a Tie
.............................................................................. 3-2
Viewing Ties (and Muting Outputs)
.................................... 3-2
Saving or Recalling a Preset
................................................... 3-3
Locking Out the Front Panel (Executive Mode)
............... 3-3
Chapter Four • Remote Control
........................................... 4-1
Selected SIS Commands
........................................................... 4-2
Establishing a network (Ethernet) connection .................... 4-2
Connection timeouts ..............................................................4-2
Number of connections ..........................................................4-3
Verbose mode .........................................................................4-3
Host-to-switcher instructions ................................................4-3
Installing and Starting the Control Program
.................... 4-8
Installing the program ........................................................... 4-8
Starting the program ............................................................. 4-9
Accessing the HTML Pages
................................................... 4-11
Loading the start-up page ................................................... 4-11
Chapter Five • Maintenance and Modifications
...... 5-1
Removing and Installing an I/O Board or Blank Panel
.. 5-2
Removing and Installing a Power Supply Module
......... 5-4
Chapter One • Introduction
................................................... 1-1
i
Fiber Matrix 6400 Switcher • Table of Contents