DVS 510 Series • Remote Configuration and Control
67
Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Advanced Configuration (continued)
HDCP Signal Status
Query input
E
I
HDCP
}
X4$
]
Request the HDCP signal status of the
current input.
Query output
E
O
HDCP
}
X4$
]
Request the HDCP signal status of the
DVI output.
Video Switch Effect
NOTE:
The video switch effect also affects the audio switch, as discussed in the following command descriptions.
Cut
E
0
SWEF
}
Swef
0
]
Set the video switch effect to
cut
. The
audio output is instantly switched to the
next input.
Fade
Swef
1
]
Set the video switch effect to Fade
(default). The audio ramps down from the
current input, then ramps up to the new
input.
View effect
E
SWEF
}
X4%
]
Show the current switch effect.
IR Receiver
Enable receiver
65
*
1
#
IRDisable
1
]
Enable the IR receiver on the
DVS front panel.
Disable receiver
65
*
0
#
IRDisable
0
]
Disable the IR receiver (default).
View IR receiver status
65
#
X1)
]
View IR receiver status.
Information Request
General information
I
Vid
X!
•
Aud
X!
•
Pip
X!
•
Typ
X#
•
Std
X1!
]
View the following device information:
Vid
= video input
Aud
= audio input
Pip
= PIP input
Typ
= video signal type
Std
= video standard (
X1!
)
Query firmware version
Q
n
.
nn
]
View the current firmware version.
Query part number
N
60-835-
nn
]
DVS 510 = 60-835-01
DVS 510 SA = 60-835-02
View internal temp.
E
20STAT
}
X1@
]
View the internal temperature in degrees
Celsius (response contains leading
zeros).
NOTE:
X!
= Input selection
1
through
10
X#
= Input signal type
1
= RGB,
2
= YUVp/HDTV,
3
= RGBcvS,
4
= YUVi,
5
= S-video,
6
= Composite,
7
= DVI
X1)
= IR receiver status
0
= IR receiver disabled,
1
= IR receiver enabled
X1!
= Input video standard
0
= No signal,
1
= NTSC 3.58,
2
= PAL,
3
= NTSC 4.43,
4
= SECAM
–
= Not applicable (occurs when the input is set to RGB or YUVp/HDTV)
X1@
= Internal temperature
Shown in degrees Celsius with leading zeros
X4$
= HDCP signal status
0
= No receiver or source device detected (analog or digital inputs or outputs)
1
= Receiver or source detected with HDCP/DPCP (digital inputs or outputs only)
2
= Receiver or source detected but no HDCP/DPCP is present (analog or
digital inputs or outputs)
X4%
= Video switching effect
0
= Cut. Instantly switches audio output to the next input.
1
= Fade. Audio ramps down from the current input, then ramps up to the
new input (default).
