DVS 510 Series • Remote Configuration and Control
55
X2%
= User presets
1
through
16
The following parameters are saved in user presets:
•
Color
•
DETAIL
•
Vertical size
•
Tint
•
Horizontal position
•
Pan
•
Contrast
•
Vertical position
•
Zoom
•
Brightness
•
Horizontal size
X2^
= Input presets
1
through
128
The following parameters are saved in input presets:
•
Input type
•
Contrast
•
Active pixels
•
Vertical position
•
Preset name
•
Brightness
•
Active lines
•
Horizontal size
•
Film mode detect
•
DETAIL
•
Pixel phase
•
Vertical size
•
Color
•
Horizontal start
•
Total pixels
•
Zoom
•
Tint
•
Vertical start
•
Horizontal position
•
Pan
X3)
= PIP window input selection
0
through
10
0
= No selection: PIP disabled
X3&
= RGB delay
0
through
50
in 0.1 second increments. Default is
05
(0.5 seconds).
X3*
= Overscan
Applies only to SMPTE input rates (NTSC, PAL, 480p, 576p, 720p, 1080i, and
1080p).
0
= 0.0% (default for RGB and DVI). A true Auto-Image is executed on SMPTE
inputs.
1
= 2.5% (default for YUVp/HDTV). An Auto-Image command snaps to a 2.5%
table.
2
= 5.0% (default for composite, S-video, YUVi, and RGBcvS). An Auto-Image
command snaps to a .0% table.
X3(
= Aspect ratio
1
= Fill
— Each input rate fills the entire output raster (default).
2
= Follow — Each input rate is displayed with its native aspect ratio.
X4)
= Power save (screen saver) modes
0
= Black screen — The scaler continues to provide output sync and muted
video with no video input (default).
1
= Blue screen — The scaler provides a blue output while still providing
continuous sync.
2
= Timed blue screen — The scaler shows blue output for 1 minute, then mutes
output video and sync.
X4@
= Video mute
0
= Unmute
1
= Mute to black
2
= Mute output video and sync
X4$
= HDCP/signal status
0
= No receiver or source device detected (analog or digital inputs or outputs)
1
= Receiver or source detected with HDCP (digital inputs or outputs only)
2
= Receiver or source detected but no HDCP present (analog or digital inputs or
outputs)