DVS 510 Series • HTML Configuration and Control
102
On the
User
Control
page, you can perform the following functions:
Selecting an input and signal type
Before selecting an input, you must select video, audio, or both for output. To select an
input:
1.
In the
Signal
Type
panel, select the radio button for the type of signal you will be
sending to the output:
•
Both
— Both audio and video will come from the same input (default).
•
Video
— Only the video signal will come from the new input.
•
Audio
— Only the audio signal will come from the new input.
2.
In the
Input
Selection
panel, click the desired input button.
The button on the screen is highlighted and its equivalent button on the front panel
lights as follows, depending on your signal type selection:
•
If you selected
Both
as the signal type, the input button on the screen is
highlighted and the equivalent front panel button lights amber.
•
If you selected either
Audio
or
Video
(audio or video breakaway), the following
occurs:
•
Video
— The screen input button is highlighted and the equivalent front panel
button lights green.
•
Audio
— The screen input button is highlighted and blinks (the blinking
continues until the audio is switched to a different input). The equivalent button
on the front panel lights red.
3.
If using audio or video breakaway, repeat steps 1 and 2 for the remaining signal type.
Configuring the audio
In the
Audio
panel, you can configure the audio signal by adjusting the following controls:
•
Mute
— Click this button to mute and unmute the audio. When audio is muted, this
button is highlighted. The default is unmuted.
•
Delay
— Click this button to delay the audio to match the video delay. When audio
delay is enabled, this button is highlighted (the default).
•
Volume
— Raise or lower the volume level by selecting a volume step (
1
through
100
) from the drop-down menu or by clicking the
+
or
–
buttons to increase or
decrease the step number.
•
Gain/Attenuation
— Set the gain level by selecting a
+
number from the drop-
down menu or the attenuation level by selecting a
–
number. Alternatively, click the
+
and
–
buttons to increase or decrease the gain or attenuation level. The default is
0
.
•
Bass
— Increase or decrease the bass by selecting a level (
-12
through
+12
) from
the drop-down menu or by clicking the
+
or
–
buttons to increase or decrease the
level. The default is
0
.
•
Treble
— Increase or decrease the treble by selecting a level (
-12
through
+12
)
from the drop-down menu or by clicking the
+
or
–
buttons to increase or decrease
the level. The default is
0
.
•
Output
format
— Click the
Mono
(for dual mono) or
Stereo
button to select the
output type. The selected button is highlighted. The default is
Stereo
.
•
Audio
Start
Up
Limiter
— (DVS 510 SA only) From the drop-down menu, select
the maximum volume level that the limiter will permit when the DVS is powered up.
You can select volume step
1
through
100
.
