DVS 510 Series • Operation
36
Set IP Address submenu
Valid IP addresses consist of four one-, two-, or three-digit numeric sub-fields (called
“octets”) that are separated by periods. Each octet can be numbered from 000 through
255 (leading zeros are inserted by the DVS). The factory-installed default address is
192.168.254.254
, but if this conflicts with other equipment at your installation, you can
change the IP address to any valid value via the
Set
IP
Address
screen.
To change the unit IP address:
1.
Press
NEXT
repeatedly until the
Set
IP
Address
screen is displayed.
2.
Rotate the horizontal
ADJUST
knob (
{
) to select an octet. (The selected octet blinks.)
3.
Rotate the vertical
ADJUST
knob (
[
) to increase or decrease the blinking number.
Set Subnet Mask submenu
The subnet mask is used to determine whether the DVS is on the same subnet as the mail
server when you are using a subnet (see
on page 118). The subnet
mask address has the same validity rules as the IP address. The default subnet mask is
255.255.000.000.
To change the subnet mask:
1.
Press
NEXT
repeatedly until the
Set
Subnet
Mask
screen is displayed.
2.
Rotate the horizontal
ADJUST
knob (
{
) to change the blinking octet selection.
3.
Rotate the vertical
ADJUST
knob (
[
) to increase or decrease the blinking number.
Set Gateway Addr submenu
The gateway address identifies the gateway to the mail server that will be used if the
scaler and the mail server are not on the same subnet. The default gateway address is
000.000.000.000
.
To change the gateway address:
1.
Press
NEXT
until the
Set
Gateway
Addr
screen is displayed.
2.
Rotate the horizontal
ADJUST
knob (
{
) to change the blinking octet selection.
3.
Rotate the vertical
ADJUST
knob (
[
) to increase or decrease the blinking number.
NOTE:
The
Edit
Comm
Settings
menu has no MAC address screen, because the
MAC address cannot be changed.
Exiting the Menu System
To exit the menu system, press the
MENU
button repeatedly until the
Exit
MENU?
Press
NEXT
screen appears. Press the
NEXT
button to return to the default cycle.
Alternatively, wait until the menu system times out and the default cycle resumes
(approximately 30 seconds).
