DTP2 T/R 211 • Installation and Operation
6
12.
In a DTP2 transmitter to DTP2 receiver configuration, set the SEND POWER
toggle switch
to the
UP
position on the powered DTP2 device to enable sending
remote power to the far end DTP2 device. Set the toggle switch to the
DOWN
position on
the DTP2 device receiving power (see
ATTENTION:
•
The DTP2 211 device is configured to output power to DTP2 models only. If
connected to a Legacy DTP device, set the toggle switch to the
DOWN
(
OFF
)
position. Failure to turn the power OFF will damage the connected Legacy
DTP device.
•
Le DTP2 211 est configuré pour fournir une alimentation aux modèles
DTP2 uniquement. S’il est connecté à un autre appareil, veuillez positionner
l’interrupteur à bascule sur «
DOWN
» (
OFF
). Si l’interrupteur n’est pas
positionné sur OFF, vous risquez d’entraîner la défaillance de l’appareil
Legacy DTP connecté.
13.
Connect power to the transmitter or receiver.
14.
Power on the source devices.
After the transmitter, the receiver, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, ensure all cables are routed and
connected properly.
NOTE:
Ensure the video source and display selected for the DDC are properly
connected to the transmitter and receiver pair, and the transmitter, receiver, and
display have power applied
before
power is applied to the video source. If the other
devices are not turned on before the video source, the image may not appear.
Connections
Transmitter Rear Panel Connections
INPUTS
POWER
12V
0.8A MAX
SIG LINK
DTP2 OUT
OVER DTP2
RS-232
IR
Tx Rx
Tx Rx
G
AUDIO
A
A
A
B
B
B
C
C
C
D
D
D
E
E
E
A
Power inlet
B
C
D
E
Figure 2.
DTP2 T 211 Transmitter Connectors
A
Power inlet
— Plug the included external 12 VDC power supply into either this 2‑pole
inlet
or
the power inlet on the receiver (see
on page 12 to wire the connector).
2
