AVT 200HD Tuner • Operation
23
Recalling presets
When a channel is saved as a preset, you can tune to that channel by selecting its preset.
Using the front panel menus, you can recall a preset that has been saved.
When you select a preset, it recalls the cable or over-the-air TV channel that was
programmed for it.
NOTE:
Channel presets that are programmed while the AVT is in either over-the-air or
CATV mode remain exclusive to the mode in which they were saved.
To recall (select and tune to) a preset channel from the front panel:
1.
Place the AVT in preset mode.
2.
Press the Up (
>
) or Down (
<
) button repeatedly until the desired preset number is
displayed on the LED panel.
•
If no presets have been saved,
the LED display flashes “P 0 0” for 2 seconds,
then returns to the currently selected channel number (or to 0.0 if no channel scan
has been performed).
•
If presets have been saved,
the currently selected preset number is displayed
for 2 seconds, then the channel number associated with the selected preset is
displayed. The LCD screen displays the preset number (or name, if you defined one
using the control software or SIS commands), along with the channel name and
number.
Example:
If preset 30 is selected via the Up or Down button in Preset mode, the
LED and LCD displays show the following:
PRESET30
AIR 28–1
After 2 seconds, the digital display shows the channel number (28.1 in this example)
associated with preset number 30.
In addition to the front panel buttons, you can use SIS commands (see the “Remote
Configuration and Control” section); the control software (see the AVT 200HD control
program help file); the AVT 200HD web pages (see “
HTML Configuration and Control
”),
or the IR remote control buttons (see “
Using the AVT 200HD IR Remote Control
,” later in
this section) to recall presets.
Selecting the output resolution and refresh rate
The following table shows the available resolutions for each video output type. The refresh
rate is fixed for each resolution. Multiple output devices can be connected to the AVT if their
resolutions are the same. Output sync polarity can be changed by an SIS command (see the
Set output polarity
command in the “Remote Configuration and Control” section) or via
the control software (see the control program help file).
