3 Insert the stripped end of the green/yellow ground cable end all the way into the barrel of the ring
terminal.
Crimp the terminal securely to the cable.
Refer to
the following figure
.
Figure 32: Attaching Terminals to Cables
Power connection wire
Ground wire
Installing the DC Power Supply
After preparing the DC cables, install the DC power supply (Model 10933 or 10934A) in the E4G-400
router.
1 If necessary, remove a blank panel as shown in
the following figure
.
Figure 33: Removing a Blank Panel
2 Verify that the power supply is right side up, and slide it into the router.
3 Carefully slide the power supply all the way into the power supply bay, as shown in the figures
below, until the latch snaps into place.
Caution
Do not slam the power supply into the router.
Installing an E4G Series Router
E4G Routers Hardware Installation Guide
52
