Installing an AC Power Supply
You can install an AC power supply in an E4G-400 router.
Warning
To prevent an electrical hazard, make sure that the AC power cord is disconnected from the
power supply before you install the power supply in the router.
Caution
Make sure the AC power supply circuit is not overloaded. Use proper precautions, such as a
circuit breaker, to prevent overcurrent conditions.
1 On the rear panel of the E4G-400 router, remove the blank panel from the power supply tray as
shown in
the following figure
.
Figure 30: Removing a Blank Panel
2 Slide the power supply into the router as shown in
the following figure
.
Figure 31: Installing an AC Power Supply
Installing an E4G Series Router
E4G Routers Hardware Installation Guide
50
