3 Align and securely tighten the retaining screws on the connector, as shown in
the following figure
.
Caution
Make sure the retaining screws are securely tightened to prevent accidental removal of the
power connector.
Figure 21: Connecting the DC Input Cable
4 Energize the DC circuit.
Installing a T1/E1 Module
Before you install a T1/E1 module (E4G-F16T1E1) on the E4G-200 router, have the following items on
hand:
•
ESD-preventive wrist strap
•
#1 Phillips screwdriver
You can install a T1/E1 module without powering down the router. However, you will need to reboot the
router to initialize the newly installed T1/E1 module.
Note
The router might reboot itself when the installation is complete. Because of this, we
recommend that you perform the installation during off-peak hours.
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an
appropriate ground point on the rack.
Installing an E4G Series Router
E4G Routers Hardware Installation Guide
43
